Anytone 878 battery case
#Anytone 878 battery case update#
version: V2.01.07 BA (same, no update necessary BT BT version: 10033 Separate TOT warning tone and acoustic signal. Changed the time of the default date to 2020. The radio is unable to switch to that channel if the channel does not belong to a zone. Press the Menu button on the radio to permanently stay on the channel with the signal when it finds a signal while scanning. Helps improve the problem of freezing the radio. CPS-> Channel -> Disable DataACK, allows you to disable the radio response to the data service request. Improved the problem that the radio has the clicking sound when scanning. CPS-> Optional Setting -> Power Save -> Auto Shut down type, allows you to set AutoPowerOff based on the call or not. CPS-> Optional Setting -> Display -> Zone Name Color, allows you to set the display color of the zone name. Sticky NEW Anytone my ultimate Guide of ANYTONE 578 mobile dmr radio by IW2BSFįirmware update D878UV V1.19 ( date ) List of changes 1. During scanning, the backlight will be turned off according to the back light settings in CPS, Firmware version: V1.17 CPS version: V1. Resolve the issue that the Encryption key is always changing when even click on the “enter” key. CPS->Optional Setting -> Display, allows to change the color of channel name. CPS->Channel->SMS Forbid, allow to turn off the SMS receive. This function helps to reduce the battery consumption. CPS->Optional Setting->Other->TxPow Agc -> ON, when the radio detects the RX signal is very strong, it will adjust the TX power one level lower, also the display will show the correct TX power level match to the actual TX power. CPS->Optional Setting->Other->TOT Predict-> ON, the radio will beep to predict TOT time will reach soon and TX will cut off. Resolve the issue that APRS-Auto TX interval setting in CPS doesn’t match the radio menu. Resolve the issue that up/down key function on microphone is reverse in VFO mode. Resolve the issue that Beep sound doesn’t work when repeater is out of range. Resolve the issue that the car audio stops when APRS is transmitting. Resolve the issue that the car audio stops when start the roaming function. Resolve the issue that in APRS section, Slot2 selection is radio broadcast for Slot1 and vice versa. Resolve the issue that when roaming is ON, the POP-up screen shows OFF. CPS->Channel ->Digital ->radom key, allows the radio transmit the radom key encyrption. (Note: When use the MKE function, make sure turn off the sub channel, otherwise the RX will be affected) 5. CPS->Channel ->Digital ->multi-key, add encryption (MKE) function. During scanning, the removed channels from channel list will revert back after switching zone. D878UV firmware update V1.17 (dated ) Change List 1.